You are here:
< Back
Note: You will need a device that has an accelerometer, and a Wallboard application version higher than 2.20.09.1

Configuration:

  1. Open the Wallboard Sensor designer application (You can find more information about the Sensor designer here: About Sensor designer)
  2. Select Android USB as a connected device.
  3. Select Lifting in the Port USB section

Lifting configuration:

  1. ID: This is the id of the sensor you can change it to anything you like.
  2. Timeout: This is the time in seconds for how long the device must not get any user input to trigger putDown
  3. liftUp:
    1. Message: This is the sensor event which will be sent to the content when the device is lifted by the user.
    2. Webhook to call: An URL if you want to call it as the device is lifted up.
  4. putDown:
    1. Message: This is the sensor event which will be sent to the content when the device wasn’t interacted with for the time of Timeout.
    2. Webhook to call: An URL if you want to call it as the device is put down.

If you would like to know more about webhooks please kindly find the information below:

About Webhooks

Note: Messages and webhooks are optional.
The timeout can be reset by moving the device and touching the screen.